banner



How To Repair Tie Loop

Introduction

Active End: The end of the tie that will exist used to tie the knot. This can be either the broad end or narrow end of the tie depending on the tie knot.

Shirt Collar: A band of material around the neck of a shirt that tin can either exist folded or unfolded.

Neck Loop: The loop of the necktie that goes around the collar.

Keeper Loop: A piece of cloth that is sewn onto the underside of the wide end of the tie that tin can exist used to keep the narrow end of the tie subconscious.

Iv-in-Hand: A simple and common knot that is incredibly versatile and appropriate for many unlike occasions.

  1. Fold the collar of your shirt up.

    • Fold the neckband of your shirt upwards.

  2. Wrap the tie around the back of your neck with the narrow end on the left side of your body and the wide end on the right side.

    • Wrap the tie effectually the dorsum of your cervix with the narrow stop on the left side of your body and the wide end on the right side.

    • The broad end of the tie will be your active terminate.

    • Note: The narrow end of the tie should exist effectually the summit of your omphalus or a little higher. It may need to adapted for personal height.

  3. Take the active end and cross it over the narrow end, so that it points to the left.

    • Take the active stop and cross it over the narrow end, then that it points to the left.

    • Notation: be sure that the tie always lays apartment so there are no twists in the fabric.

  4. Wrap active end under the narrow end, so that it now points to the right.

    • Wrap agile end nether the narrow end, and then that it at present points to the right.

  5. Wrap active end over the narrow end, so that it now points to the left.

    • Wrap active end over the narrow end, then that information technology now points to the left.

    • Note: exit this wrap a little loose, every bit it will be used in pace 7.

  6. Pull the active end up through the neck loop, so that it now points up.

    • Pull the agile terminate up through the neck loop, so that it now points upwardly.

  7. Pull the active end down through the wrap you created in step 5 (see second picture). Pull the active end down through the wrap you created in step 5 (see second picture).

    • Pull the active stop down through the wrap you created in step five (see second picture).

  8. Tighten the knot by pulling down on the active end and up on the knot, adjusting for size and evenness.

    • Tighten the knot by pulling downwardly on the active end and up on the knot, adjusting for size and evenness.

  9. Tighten the neck loop by pulling down on the narrow end of the tie and sliding the knot up toward your neck.

    • Tighten the neck loop past pulling down on the narrow stop of the necktie and sliding the knot upwards toward your neck.

  10. Tuck the narrow end of the tie through the keeper loop.

    • Tuck the narrow finish of the tie through the keeper loop.

    • Note: if the narrow end is too long, a simple solution lies in tucking the narrow terminate between two buttons of your shirt.

    • Fold your collar down when the knot is finished.

Conclusion

Congratulations! You've successful tied the Four-in-Hand knot!

Team

Embed this guide

Choose a size and copy the code below to embed this guide as a small-scale widget on your site / forum.

Preview

How To Repair Tie Loop,

Source: https://www.ifixit.com/Guide/How+to+Tie+a+Tie:+Four-in-Hand/85392

Posted by: herrmannquism1987.blogspot.com

0 Response to "How To Repair Tie Loop"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel