How To Repair Bathroom Towell Bar

How to Permanently Anchor a Bath Towel Bar

Updated: Jan. 31, 2022

A permanent fix for wobbly towel bars

Family Handyman

Towel bars mounted on drywall need to exist firmly anchored or they'll eventually fall off. Replace calorie-free-duty plastic anchors with heavy-duty anchors that will keep towel confined in identify even after years of hard use.

Set up loose towel bars with amend anchors

Loosen the setscrew

Loosen the setscrew that fastens the post to the mounting plate. Remove the post and the bar. And so unscrew the mounting plate from the wall and remove the old anchors.

Bulldoze in the anchor

Drive the toggle ballast into the onetime anchor holes with a drill containing a No. 2 Phillips fleck.

Close upwardly of toggle anchors and screws

Tighten the screw

Refasten the mounting plate with the long toggle screws. Then reinstall the postal service and the bar.

When towel confined come loose, it's usually because they weren't well fastened in the commencement identify. The pocket-sized, wimpy wall anchors included with well-nigh towel bar sets just don't have enough belongings power. Merely with sturdy new anchors, you can remount towel bars so they'll never come up loose again. Don't put off this fix. The longer you wait, the more likely you are to scar the wall or mar the bar's finish. You can besides utilize these techniques to remount towel rings, toilet paper holders and hooks besides. Everything you need is bachelor at domicile centers and hardware stores.

How to hang a towel rack begins first by removing the loose terminate posts. If 1 mail is rock solid, leave it in identify (chances are it's fastened to a wall stud). Yous'll need a hex wrench or mini screwdriver to loosen the setscrew. There's a slight run a risk that the existing anchors are adequate but the screws have loosened. And so try to tighten the screws that hold the mounting plates in place. If they tighten up deeply, just remount the posts and the bar. If they don't tighten firmly, remove the screws and the mounting plates. To remove the old anchors, pry them out with a screwdriver or poke them in and let them fall inside the wall.

For fast, solid mounting on drywall, use toggle anchors. These clever anchors are self-drilling and have a T-clench that folds out when you push the screw into the shaft.

Anchoring in Tile

On tile, 1/4-in. tubular plastic anchors agree firmly, whether at that place's drywall or cement backer board behind the tile. Be sure to purchase tube-shaped anchors equally shown here, not tapered anchors, which don't hold as well.

Overstate the original anchor holes with a 1/4-in. carbide drinking glass-and-tile bit. Tap in the plastic anchors and fasten the mounting plate with screws.

Required Tools for this Projection

Accept the necessary tools for this DIY how to hang a towel rack projection lined up earlier you lot beginning—you'll save fourth dimension and frustration.

1/iv-in. carbide glass-and-tile bit

Required Materials for this Project

Avoid last-minute shopping trips past having all your materials prepare ahead of time. Here's a list.

Originally Published: November 28, 2022